I've seen these listed between $23-$33 but they don't give any specs of the roller's size. Is this the same for all Graphtecs? ie FC CE models. (Novacut etc.) However I cannot find the info I need about the pinch roller and drivers.Īs best as I can measure with a HF caliper, my pinch roller has an axle size of 3.96mm, a width of 10.56mm, and a roller diameter of 15.06mm With some assist from me on the right side the cutter did load a scrap piece of vinyl and seemed to be ready to go.įrom searching the forum I know that is is similar to other branded cutters made during the same time that this dino was made. So I cannot run a real test til I get another roller. I say "seems" because it is missing the right pinch roller (just the wheel part). I got it home and without the blade in it I powered it up and it POSTed fine. With stand and a bunch of partial rolls of various vinyl) So far I think I am doing good, cause I only have $10 invested. Mostly for small graphics 12inx12in in size. So I would like to use it as a cutter only. Based on other posts I found about this machine it seems this machine cuts and cuts and cuts but as a printer it printed mehh at best. I know the printing system is not worth attempting to revive, as this machine sat for a very long time with/without ink.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |